Du hast rect - 38 ist nicht zu finden! Gruss Otto

---

Re: Fehlercode 38

Von abraham am 24.10.2004, 23:56

Code 38 Lockup control Note: When controller called for lockup it saw a slip or no lockup at all. Diagnostic Tip This code is usually set after an overhaul and has 3 possible causes 1. - Pump Wear - Any amount of wear in the pump pocket between suction and discharge will cause low pressures to the lockup apply surface of the converter clutch. 2. - Torque Converter - A poor quality rebuilt will cause slippage of the converter clutch. 3. - Solenoid switch valve stuck in L/R position in the valve body causing no lockup. The problem is most often the pump. Next is the torque converter. Last is the SSV valve stuck in the valve body. Important:Most shops when they encounter code 38 replace both the pump and the torque converter at the same time to avoid a 3rd R and R.

---

Re: Fehlercode 38

Von Sanna 3.0.V6 A604 Coupé 91 am 25.10.2004, 11:45